HOLDEN VE, WM and FORD BA, BF, FG & TERRITORY HVAC SCAN TOOL

Published 01/05/2011

 http://radshop-new-test.prontoavenue.biz/ts1539791414/attachments/BlogPost/27/TSB%2046%204-11%20New%20Release%20of%20HVAC%20Scan%20Tools.pdf

We at Adair are excited to announce the release of the only dedicated “HVAC” scan tool in Australia. Rather than pay big bucks for a scan tool that can diagnose all the vehicle operating systems, we can offer a scan tool that only looks at what we care about, which is the HVAC. There are two (2) separate low cost scan tools available for the most popular locally produced vehicles Holden and Ford. These scan tools take a lot of the guess work out of HVAC diagnosis. With the aid of these scan tools you can now diagnose, calibrate and reprogram the following
HVAC module information:

• Set gender - Single zone, dual zone and tri-zone.
• View DTC’s (diagnostic trouble codes).
• Erase DTC’s.
• Operate mode door positions.
• Operate temperature door positions.
• Operate blower fan speeds.
• Operate the electronic controlled compressor on the VE, WM to minimum and maximum position.
• Check accuracy of all the sensors.
• Reprogram the mode, temperature door minimum and maximum positions.
• Confirm high side pressure reading from pressure transducer. Holden VE, WM.
• And more…………………………………………

Adair HVAC Scan tool part numbers:
Holden – TUNI217
Ford – TUNI218
Contact your state Adrad branch or Radshop.
Scan tool plug connects to the vehicle DLC (diagnostic link connector)